To avoid problems with stale DNS cache entries, you might decide to implement NLB or Network Load Balancing.

To configure NLB Cluster, we will install the NLB feature on each of the FARM members and then configure the cluster and finally add a DNS entry mapping the FARM name to the Cluster IP address.

Starting with Windows Server 2008, NLB was re-engineered so that implementing NLB in the unicast mode on one network adapter now allows for host to host communication.

To install NLB, yes, you guessed it right Smile, use the ServerManager Module

So, we will install the NLB feature first on COLFAX.

clip_image002

clip_image004

Next, we will install NLB feature on the FUJI server. Note here, I would use the 1:1 Remoting Feature of PowerShell as shown below.

clip_image006

Like RDS, NLB also installs a PowerShell Module so that we can consume it to create NLB clusters via PowerShell

clip_image008

Next, let’s quickly examine the commands available in NLB Cluster Module. Note that we can use the wildcard characters to specify the name of the module. I am a bit lazy to type the entire name again J.

clip_image010

We will use the New-NLBCluster command to create a NLB Cluster as shown in the screenshot below:

clip_image012

You can get information about the NLBCluster just created using the Get-NLBCluster command.

clip_image014

Now, let’s add the COLFAX server to the NLBCluster

clip_image016

And that’s all about it. Smile

clip_image018

Let’s check the same in the NLB Manager.

clip_image020