Gerod Serafin's WebLog

Helping to keep large organizations' e-mail running

Part 21 - I used to do it this way… Now how do I do it? Administering Exchange 2003 vs. Exchange 2007

Part 21 - I used to do it this way… Now how do I do it? Administering Exchange 2003 vs. Exchange 2007

  • Comments 2
  • Likes

To return to part 1 click here

Transport

POP3 and IMAP4

In Exchange 2003, POP3 and IMAP4 were both receive-only protocols that enabled a client to receive e-mail. To send e-mail, these clients had to relay SMTP traffic through the Exchange organization.

Below you can see that the IMAP Virtual Server is disabled.

image

The default properties of the IMAP4 Virtual Server…

image

To enable the protocol on the users you would use the Exchange Task Wizard.

image

In Exchange 2007, every Hub Transport server has a default client Receive connector that allows authenticated POP3 and IMAP4 users to relay SMTP e-mail through the Hub Transport server. You must specifically enable POP3 or IMAP4 access for clients.

The protocols are listed on the CAS servers.

image

Here are some of the default properties on IMAP4.

image

You can enable IMAP4 and POP3 on the mailboxes from within the Exchange Messaging Console.

image

More information on configuration can be found at the links below:

How to Set Connection Limits for IMAP4

How to Configure Authentication for IMAP4

How to Set Connection Limits for POP3

How to Configure Authentication for POP3

Securing message transmission by using Transport Layer Security (TLS)

In Exchange 2003, if you required TLS for inbound connections you configured the authentication settings on a virtual server. You accessed the virtual server properties, and then selected a check box to require SSL/TLS on the Access and Authentication settings page.

image

In Exchange 2007, you configure TLS on a Receive connector by specifying TLS as an available authentication mechanism. However, you need to have an X.509 certificate installed on the Exchange server. For more information see Receive Connectors.

image

You could also set this using :

Set-ReceiveConnector -Identity ReceiveConnectorId -AuthMechanism Tls

Next:  I think that is it.  Hopefully you found this useful.  It took so long to do this, I could start on Exchange 14.  Hmmm.

Comments
  • To return to part 1 click here Transport Outbound SMTP connections to other messaging servers In Exchange

  • Bravo Gerod - thanks very much for your time. I have found this very useful. Thanks again

Your comment has been posted.   Close
Thank you, your comment requires moderation so it may take a while to appear.   Close
Leave a Comment