Currently, we have no script to rebuild WMI in Windows 7 client. Following is the procedure to rebuild WMI in Windows 7.
1) Perform a manual logcopy on the PC. 2) Open an elevated command prompt. 3) Verify the WMI repository is not corrupt by running the following command:
If the repository is not corrupted, a “WMI Repository is consistent” message will be returned. If you get something else, go to step 4.
4) Run the following commands:
If the repository salvage fails to work, then run the following command to see if it resolves the issue: winmgmt /resetrepository
After the last command, there should be a “WMI Repository has been reset” message returned.
NOTE: We always use winmgmt /resetrepository to repair the WMI in the Windows 7 client.
Thank you very much for sharing this!