Browse by Tags
All Tags »
DPM (RSS)
Sorry, but there are no more tags available to filter with.
In the previous post, we covered the steps necessary to setup DPM and SharePoint to allow recovery of any SharePoint object from a single file up to the entire Farm. In this post, we will cover the worst-case scenario in which the entire farm has
Read More...
To enable the end-user recovery in DPM 2007 on a Windows 2008 Server you should click on the recovery tab and then under actions (on the left hand side) click on “Configure end-user recovery…” link. This will launch a wizard to
Read More...
With SharePoint gaining popularity in the last year and the recent release of DPM 2007 which supports the protection of SharePoint this has become a hot topic in the last few months. The protection and recovery of SharePoint data is not small undertaking
Read More...
Article http://technet.microsoft.com/en-us/library/bb808814(TechNet.10).aspx describes how to install DPM on to a 2008 Server. However I have found that this article is incomplete. The following is how to install DPM onto a 2008 Server. After the 2008
Read More...
In Data Protection Manager 2007, when configuring a protection group for protection of Exchange data for the versions that DPM supports (Exchange Server 2003 w/SP2 or higher and 2007), you are given an option to enable execution of ESEUTIL.EXE against
Read More...
If you are protecting more than one domain controller, and using more than one DPM server to do it, you may experience an issue where at random times, all servers being protected by Data Protection Manager ("DPM") may lose connection with the
Read More...
If the information under the Libraries tab in the Management Task area does not show up correctly: Follow the steps below to remap the tape drive information. Stop the DPMLA service if it is running Remove any tapes from the drive and insert at least
Read More...
951557 (article not yet published) Description of the Data Protection Manager 2007 hotfix rollup 3 Issues Resolved - Recovery of SSL Sites does not work - Consistency Check on compressed volume results in full Initial Replication -
Read More...
The DPM agent is a DCOM application - it cannot function correctly without proper DCOM configuration. This section covers the necessary configuration checks to make sure that DCOM is configured correctly. Non-Clustered Member Servers: As a rule, DCOM
Read More...
The following is a comprehensive list of operating systems that are supported as protected machines and/or meet the requirements to run System Center Data Protection Manager (DPM) 2007. Important: DPM supports 32-bit and x64-bit operating systems.
Read More...
Note: This is the second of a three part series for troubleshooting the DPM RA (Data Protection Manager Remote Agent). Please check out the earlier blog, and the next (all start with the same title). Network security protocols between the
Read More...
Microsoft’s Data Protection Manager (DPM) version 2007 must have an agent installed on any server or workstation that it is going to protect. The installation of the DPM agent requires contact with many different components both locally
Read More...
